Creating a WebRTC Output

creating a webrtc output zixi broadcaster can transcode a ts stream input into a webrtc output using the relevant profiles, depending on the input video and audio, as described in the video and audio codec support options docid nigy0zx1u8xbh 7x0p5f section before creating the webrtc output, make sure you have configured the relevant transcoding profiles, see creating transcoding profiles for webrtc docid 5uabtvs7oxphg hdkygao when the input stream is transcoded, it becomes available to be pulled by the webrtc player not supported on arm based systems to create a webrtc output create an input stream by following the instructions in the adding input streams docid\ sh6vga41l8ypx82admtil section of the broadcaster user guide click the actions button on the right end of the input stream row, and then click transcode the transcode \<input stream name> window with the settings of the selected input stream is displayed enter the unique stream id , which will correspond to the new transcoded input that will be added in the output type field, select webrtc under stream parameters , in the video profile field, select the desired video profile for the desired method only supported profiles are shown if you would like to remove the video or audio stream completely, select remove stream pass through – select keep original stream single version transcoding – select a profile that converts to h 264 with main or baseline profile and no b frames multiple version transcoding – select a profile that converts to raw video in the audio profile field, select the desired audio profile for the desired method only supported profiles are shown if you would like to remove the video or audio stream completely, select remove stream configure additional parameters as required, see transcoding an input stream docid\ xdnbysxp yjdeogpgwopj click ok the transcoded input stream is created and appears in an embedded window labeled transcoded sources under the original input stream from which it was created